Company CITYEQUIP offers a range of mobile jaw crushers, electric and diesel-electric drive. Crusher designed to crush concrete, rocks, construction debris, etc.    

 The size of the inlet opening  crushing site 700 x 500 mm 

Basic equipment includes a hopper with a grate separator, crushing unit, power unit, discharge conveyor and a frame.

Additional options:

- Magnetic separator;

- Lateral pipeline;

- Magic Eye Feed control : the device inside the crusher, which automatically monitors the feeder;

- Wolffs Leg Stand for loading the machine front loader without a crane.

Hopper:

-            hopper size 3.500 mm x 2.000 mm

-            Vibrating Feeder 650 mm x 3.000 mm with a primary grizzly 60 mm

-            controlled by two eccentric motors x 1.0 KW

-            coating hopper and feeder Hardox 6 mm

Jaw Crusher (crushing unit):

-            the size of the inlet opening 700 x 500 mm

-            capacity 45 - 130 tons / hour depending on the configuration of CSS and material

-            adjustment range CSS (discharge gap) of 30 mm to 140 mm and adjustable hydraulic hand pump

-            speed mobile cheeks - 340 rpm.

An electric motor 37 kw - 1475 rpm. with Remneva drive   and protections.

Control Panel:

-            control panel with protection from fur. damage and moisture

-            main switch, emergency stop button and alarm button front

-            Management: feeder, crusher discharge conveyor and magnetic separator.

Discharge conveyor , 800 mm   x 7700 mm, formed by hand.

-            folding mechanism is placed behind the magnet, which allows the magnet to remain in the operating position during transport

-            EP 400, 4:2 coat drive drum diameter 315 mm, covered with a layer of rubber

-            conveyor discharge height 2800 mm.

Welded Chassis:

-            full compliance with the specification of DIN .

-            height during transport on a low trailer is 3 000 mm

-            width for transportation on a low trailer is 2.500 mm

-            Conveying length 12 000 mm

-            Working height 3650 mm

-            Working length   9500 mm

-            working width 2300 mm

-            total weight 15 000 kg, including a magnet and a diesel generator.

Magnet:

-            located above the discharge conveyor, it remains in position during transportation,

-            power 400 Gauss at a distance of 250 mm to 1000 mm from the top of the conveyor,

-            chevron belt width 750 mm, the driving drum and rear drum

-            the tension and drive motor.

Discharge Conveyor:

-            for loading pre-sifted material, width 700 mm, 3000 mm length.

Frequency of the control panel:

-            to adjust the speed options feeder.

Magic eye level inside the crusher device that automatically controls the work of the feeder

-            comes as an addition to the manual system, stop and start;

-            control of the load level grinders, starting and stopping   with the feeder relay settings;

-            Installation in control panel and wiring.

Diesel generator

-           100 kVA / 120 KW , 220-400 Volt , 50 Hz ;

-            Engine Cooling: John Deere 4045 Dieselmotor type HFS 73, 103 KW at 1.500 rpm.;

-            generator Leroy Somer , 100 KVA ; jack connection with the control panel;

-           set to CitySkid 7 V 4.

Wheels and telescopic support

-            means for transporting the crusher front-end loader

-            maximum speed of 5 km / h on a flat surface,

-            maximum load on each wheel 8 ton,

-            transport height with wheels: 3,03 m

-            transport width with wheels: 2,50 m

-            adaptation to Wolff ' s Leg loading without the crane (see Wolff ' s Leg )

-            pre-shipment check rates Loader

Wolff ` s Leg                                                    

-            support for:

            a ) move CitySkid on a transport platform without a crane,   wheel loader

            b ) raising the rear of the machine on wheels and telescoping supports.

Weight   setting:

basic model:    7V3: 12.300 kg

                               7V4: 14.300 kg

magnetic separator:  700 kg

Side conveyor:      600 kg

 Warranty: 12 months or 2000 meter (which factor comes first).